Increase the separation between the equipment and receiver. Reorient or relocate the receiving antenna. Interference by one or more of the following measures: Television reception, which can be determined by turning theĮquipment off and on, the user is encouraged to try to correct the If this equipment does cause harmful interference to radio or Guarantee that interference will not occur in a particular installation. Harmful interference to radio communications. Installed and used in accordance with the instructions, may cause Generates uses and can radiate radio frequency energy and, if not Harmful interference in a residential installation. These limits are designed to provide reasonable protection against Limits for a Class B digital device, pursuant to part 15 of the FCC NOTE: This equipment has been tested and found to comply with the Such modifications could void the user’s authority to operate the
Interference caused by unauthorized modifications to this equipment.
NOTE: The manufacturer is not responsible for any radio or TV Received, including interference that may cause undesired operation. Harmful interference, and (2) this device must accept any interference Subject to the following two conditions: (1) This device may not cause This device complies with Part 15 of the FCC Rules. The party responsible for compliance could void the user's authority to
Support for Bluetooth v4.0 specification features :įCC Caution: Any changes or modifications not expressly approved by Real-time digitised RSSI available on HCI interfaceĬSR's Bluetooth Protocol Stack runs on the on-chip MCU: Receive sensitivity of -91 dBm for basic rateĭigital demodulator for improved sensitivity and co-channel rejection No external trimming is required in productionĩ.5dBm RF transmit power with level control from on-chip 6-bit DAC over a dynamicĬlass 1,Class 2 and Class 3 support without need for external PA or TX/RX switch Integrated balun (50Ω impedance in TX and RX modes) Support for Bluetooth basic rate/EDR and low energy connectionsģ Bluetooth low energy connections at the same time as basic rate A2DP This ensures that production costs are minimised.īluetooth designs requiring the USB interface and an HCI interface Including no requirement for an external balun.
Radio and baseband IC for Bluetooth 2.4 GHz systemsĭedicated signal and baseband processing is included for full Bluetooth operation.ĬSR designed CSR8510 WLCSP to reduce PCB area and the number of external components , Green (RoHS compliant and no antimony or halogenated flame retardants)ĭesign optimised for low-cost PCB manufactureīluetooth low energy Support Heart rate belt, Find me, Proximity, Generic Attribute Profileĭual-mode Bluetooth low energy radio USB dongleīlueCore CSR8510 A06 WLSCP is a product from CSR's Connectivity Centre. No external regulators required for USB supply operation Fully qualified Bluetooth v4.0 specification systemĭual-mode Bluetooth /Bluetooth low energyĭraft Bluetooth low energy HID boot mode supportįull-speed Bluetooth operation with full piconet and scatternet support